The conveyor in the photo is equipped with EPC and dries solid sugar. Belt width is 350mm.
Before introduction of EPC, V-guide often came off the belt and production halted. Now this trouble does not happen any more for this user.
Tuesday, April 24, 2012
Friday, April 20, 2012
Steel Belt and Tracking 11 Belt Dimension
This chart above recommends tracking methods to various belt dimensions.
Yellow area: Crown pulley and V-guide
Red area: EPC, Edge Positioning Control
Blue area: requires further research on feasibility of EPC
We will continue our study to improve function of EPC on high temperature, wide belts, and high belt speed.
Labels:
belt tracking,
high belt speed,
high temperature,
wide belts
Wednesday, April 18, 2012
Thank you very much for your visit to FILM TECH JAPAN!
we’d like to express our hearty thanks.
Picture in the right shows film vacuum conveyor displayed at this show.
It holds paper, films, and tiny electronic parts with vacuum. Edge positioning control system is equipped for tracking.
Please kindly send your comments and questions on our products and service to overseas@dymco.co.jp
Wednesday, March 21, 2012
Steel Belt and Tracking 10: Edge Positioning ControlCase 1
EPC worked when belt width was 500mm and conveyor length was 3000mm. Temperature was from 20 to 300 degrees C. In general under these temperature there appear deformations and waves. These deformations hamper tracking by crown pulleys, while V-guides begin to deteriorate due to heat. However, this 500mm-wide belt rotated fine with EPC and we could obtain data as below that shows waves along belt width direction.
Wednesday, March 7, 2012
DYMCO exhibit FILM TECH JAPAN in TOKYO
DYMCO welcome you at "Film Tech JAPAN" 3rd Highly-functional Film Technology Expo.
-Date: April 11 Wed - 13 Fri, 2012
-Time: 10:00-18:00 Last day of 13th 10:00-17:00
-Place: Tokyo Big Sight
-Dymco Booth : EAST 16-2
-Language: Korean, English, and Japanese
-Displayed are Seamless SUS belts and Air Rolls for nipping application in extrusion, rapid cooling, lamination, and double press configuration.
-Admission: Please kindly register at URL: http://www.filmtech.jp/en
-Meeting appointment: overseas@dymco.co.jp +81-45-780-5575
We look forward to seeing you at Film Tech Japan !
Wednesday, February 22, 2012
Steel Belt and Tracking 9: Air source of Edge Positioning Control
0.5MPa of air pressure is required in minimum, while during operation it uses only around 50 ml/min. On air supply we do give you advise. We recommend a handy compressor when you do not find air supply utility. Or employment of a booster or increase of bore diameter may be adequate when pressure is not prepared to the full extent.
Tuesday, February 14, 2012
Steel Belt and Tracking 8: EPC / Edge Positioning Control
Edge positioning is controlled by difference in pressure supplied to these 2 cylinders.
When the belt goes straight, supplied pressure is constant.
On the other hand when the belt leans to either right or left direction, air cylinder pressure on the leaned side is increased by control circuit, moving the belt to the opposite side.
Air cylinders are required to be heat-resistive, anticorrosive, and others, depending on operating conditions.
When the belt goes straight, supplied pressure is constant.
On the other hand when the belt leans to either right or left direction, air cylinder pressure on the leaned side is increased by control circuit, moving the belt to the opposite side.
Air cylinders are required to be heat-resistive, anticorrosive, and others, depending on operating conditions.
Subscribe to:
Posts (Atom)